The printer kit finally arrived after MONTHS of waiting. I assume this kit will be an amazing starting printer since the backorder list was so large. The bit of research I did rate this printer the best under 1K. We will soon see if this was a smart decision. I think it will be a great investment assuming I am able to learn how to design and print things that I have thought up. I have a few quadcopter parts that I would like to design. I also have already designed a pen holder to print. That will be one of my first prints!. It will be a blast assembling the printer with a couple FPV buddies. I have looked at the manual that is posted on the Prusa site they seem like a great set of instructions! I look forward to being able to take things from concept to reality using only my imagination and OpenScad. LOL
I cannot wait to get started putting this together. I will create a post of how the assembly went that should be coming in the next couple weeks. I did build a table to hold the printer I have not had a chance to stain it yet so I am guessing it will not be stained before the printer is assembled. I might get to it during the week but I doubt I will have enough time. It would be much better to get some stain in it since its just cheap pine. We will see if time permits and/or I can just hold off on printer assembly to take a weekend to stain the table.
It has been a while since I have posted anything since the last couple months have been super busy with work and travel. It should be slowing down a bit so hopefully, I can catch up on the posts!