Prusa i3 MK3 removing print from print bed.

I was going to make a post about this with the rose but my wife got up before me! She went in and took it off to bring in and show me how it looked. LOL It was sweet that she like it but I wanted to make a video of how you remove it from the print bed. That is where this one comes in I beat her to the printer this time! 😉
Removing a print from the Prusa i3 MK3 print bed is so easy. Just lift the magnetic bed and flex it to release the item. It is that easy!

You will notice several little strings of the filament in this print. I am guessing that is normal but will look into it. I did take a lighter and just pass a flame over them quickly. That seemed to take care of it without hurting the print.

 

Leave a Reply

Your email address will not be published. Required fields are marked *